On-site testing scope
Inspection standards applied at the factory floor
We test beauty equipment on site against electrical, mechanical, and surface standards, so problems are found before production is shipped.
Three checkpoints
Inspection at every stage
Each factory visit follows the same structured sequence, from incoming materials to the final unit.
Stage one
Incoming material checks
We verify components, housings, and raw materials against the agreed specification before assembly begins.
Stage two
In-line assembly review
Defect identification and dimensional checks during mechanical assembly catch faults while they are still inexpensive to fix.
Stage three
Pre-shipment inspection
Final testing confirms wiring, power units, and technical housings perform to standard before any unit leaves the factory.
Standardized reporting
Every check, documented
After each factory visit you receive a standardized report with raw photographic documentation from every check. Findings are recorded as observed, so you can review the evidence yourself rather than relying on summary claims.
Reports follow one consistent format, making it straightforward to compare results across factories, production runs, and inspection dates.
